PRODUCTS

All Our Boilers are provided with Overseas Engineering Service And One Year Warranty.
Gas or Oil Fired Integrated Hot Water Boiler

Gas or Oil Fired Integrated Hot Water Boiler

Rated thermal power: 0.7-14MW Rated thermal efficiency: 96-98%

Read More Get a quote
Gas or Oil Fired Split Hot Water Boiler

Gas or Oil Fired Split Hot Water Boiler

Rated thermal power: 0.7-14MW Rated thermal efficiency: 94-96%

Read More Get a quote
Gas Fired Vertical Hot Water Boiler V6

Gas Fired Vertical Hot Water Boiler V6

Rated thermal power: 99KW Rated thermal efficiency: 104.4%(low temperature condition)

Read More Get a quote

heat recovery steam generator for applications and uses

3.1 Stationary Gas Turbines

3.1 Stationary Gas Turbines 3.1.1 General1 Gas turbines, also called “combustion turbines”, are used in a broad scope of applications ... recovered in a heat recovery steam generator to raise process steam, with or without supplementary firing (cogenerati

Learn More

4.3 Gas Turbines - UnderstandingCHP.com

The economics of gas turbines in process applications depend on effective use of the thermal energy contained in the exhaust gas, which generally represents 60 to 70% of the inlet fuel energy. The most common use of this energy is for steam generation in

Learn More

A SOURCEBOOK FOR INDUSTRY - Department of Energy

Steam is generated in a boiler or a heat recovery steam generator by transferring the heat of combustion gases to water. When water absorbs enough heat, it changes phase from liquid to steam. In some boilers, a superheater further increases the energy con

Learn More

About OTSG | IST

Once Through Heat Recovery Steam Generators (OTSGs) are the most significant advancement in steam generation in over a century. Until the 1980s, conventional drum boilers were used to produce steam. At about this time, the US Navy investigated the use of

Learn More

Basics of Steam Generation - Energiteknik | KTH

boiler is the part of a steam power plant process that produces the steam and thus provides the heat. The steam or hot water under pressure can then be used for transferring the heat to a process that consumes the heat in the steam and turns it into work.

Learn More

CHAPTER Utilities and Energy Efficient Design 3 - Elsevier

city using a gas-turbine cogeneration plant with a heat recovery steam generator (waste-heat boiler) to raise steam (Figure 3.1). The overall thermal efficiency of such systems can be in the range 70% to 80%; compared with the 30% to 40% obtained from a c

Learn More

CHP Makes Sense for Universities - Plant Engineering

4/27/2017 · Combined heat and power (CHP) uses byproduct heat from electric generation as the energy source for other applications such as steam for space heating, domestic hot water and/or absorption cooling. CHP, sometimes also called co-generation, rep

Learn More

Clayton Heat Recovery - Steam Boilers and Steam Generators by

The Clayton Waste Heat Recovery System can be used to generate steam or high temperature hot water. Typical combina-tions of an exhaust gas or waste heat unit with a direct fired steam generator are shown on page 5. A principal feature of the Clay-ton Was

Learn More

Cogeneration and CHP Congeneration Technology Basics

All generators for sale produce a certain degree of heat during electricity generation which can be utilized in a method called cogeneration. Cogeneration, or waste heat recovery, can be used to both heat and cool large buildings or use potential energy t

Learn More

Combined cycle gas turbines | IPIECA

4/10/2013 · Category: Power and heat generation. A combined-cycle power system typically uses a gas turbine to drive an electrical generator, and recovers waste heat from the turbine exhaust to generate steam. The steam from waste heat is run through a st

Learn More

Combined Cycle Plant for Power Generation- Introduction

Combined cycle operation employs a heat recovery steam generator (HRSG) that captures heat from high temperature exhaust gases to produce steam, which is then supplied to a steam turbine to generate additional electric power. The process for creating stea

Learn More

Combined Cycle Power Plants - I mia

IMIA Workgroup 92(15) – Combined Cycle Power Plants _____ Natural gas or liquid fuel is burned in the combustion turbine (1) creating a constant pressure which spins a generator (2) producing electricity. The combustion turbine exhaust waste heat and mass

Learn More

Combined-Cycle Power Plant – How it Works | GE Power

A combined-cycle power plant uses both a gas and a steam turbine together to produce up to 50 percent more electricity from the same fuel than a traditional simple-cycle plant. The waste heat from the gas turbine is routed to the nearby steam turbine, whi

Learn More

Difference Between Heat Recovery Steam Generators (HRSG

Heat Recovery Steam Generators - HRSG,s are an important part of the Combined Cycle Plant. How is it different from the combustion boilers? Some of the main differences are given in this article. Heat Recovery Steam Generator's (HRSG's) are waste heat boi

Learn More

EPRI Public Site

sending... searching...

Learn More

Submit Demands Online